Recipes › Pumpkin & Potato Pasties

Pumpkin & Potato Pasties

Preparation Time
15 minutes (excludes filling)

Cooking Time
25 minutes (excludes filling)

Serves 5 - 6

We created this filling as a tasty and quick alternative to the traditional meat and potato one and it has charmed many customers and show visitors. It can be made ahead and used cold, and always allow it to cool slightly before using if making for immediate use.

By Innovative




225g/8oz PURE Bread Flour
112g/4oz Butter/Hard Margarine
Pinch Salt
5 - 6 tbs Cold Water


350g/12oz Potato (finely diced)
350g/12oz Pumpkin or Butternut Squash
3 - 4 tsp Vegetable Bouillon Powder
½ tsp Ground Ginger
½ tsp Ground Nutmeg
5 - 6 tbs Water

Preparation Method

  1. Weigh all the filling ingredients into a small saucepan and apply a low heat for 20 - 25 minutes, or until the potato and pumpkin have cooked. Keep the lid on the saucepan during cooking.
  2. Weigh out the flour and salt into a bowl and rub in the butter/margarine until it resembles breadcrumbs.
  3. Add 5 - 6 tbsp of cold water to bring the mix together. The pastry dough will look and feel like there is too much water in it, but this is fine. For best results wrap the pastry in cling film or put into an airtight tub and refrigerate for at least 30 minutes before use.
  4. On a well dusted surface, knead/work the pastry for 1 - 2 minutes (this makes the pastry smoother and easier to work with). Roll out the pastry to the required thickness and cut to shape using a plate or bowl to cut around.
  5. Place 2-3 tbsp of pasty filling on one half of the pastry and carefully lift the other half over the filling. Seal the edges by running a wet finger around the pastry and pressing together. (You can also use beaten egg or milk to do this). If you like to glaze your pastry you can do so by brushing it with either beaten egg or milk (this helps the pastry to brown).
  6. Place the pasties on a greased baking sheet and bake at 200°C/400°F/Gas Mark 6 for 15-20 minutes.
  7. Remove from the oven and allow to cool for a couple of minutes before transferring them onto a wire rack.